OR whatever you fancy :-) Most parts I've printed in 30%. The nose / rear feet should be in black, the rest in dark grey. I've started to swap over to ABS as it's a little more flexible and I seem to be getting a better finish. :-)įirst, I would print all the parts out. I've posted some photos below which should help. The build is quote straight forward, not that many body components really. You will also need some screws, bits of wire and lots and lots of luck -) Mini 50A DalRC Power Distribution Board Hub PDB BEC - £4.25 ebay.
NZ Super Mini Ublox 7 GPS - £13 off ebay. (was 1800kv but swapped to 1200kv)ĭeluxe SP Racing F3 Flight Controller 10DOF Integrated OSD - £22.00 from Amazon UK. I might however need to widen the holes in the legs. however I think they will be fine.) I went for these because of the built in ESC as space will be tight and they will help with any possible heat issues.
Multistar LiHV High Capacity 3000mAh 3S off Hobbyking - £14.79 (got two of these.)īlack Widow 2208 1200KV With Built-In ESC off Hobbyking - £12.21 each (on offer as these are V1 and V2 are now out.
#Clone 5 rar full#
WS2812B 2*2 4-Bit Full Color 5050 RGB LED off eBay - £2.50 (some indicator led's for the back I hope depending on the FC) 24th Feb 2017 - Improved top platesĬopy Mavic props 8330 off eBay - £9 (hopefully I can print an adaptor plate) 8th March 2017 - Improved legs / added ball plungersĪdded 4mm ball holes in the middle + increased the thickness of the rear wings to 4mmĪdded 7mm holes to the front arms & lowered the wire channel increasing the strengthĪdded 4mm dimples to the rear arms and lowered the wire channel increasing the strengthīuild now updated with ball plungers which are 6mm wide x 7mm depth. (shared parts now are Top front, Middle, Nose, Gimbal holder) 23rd April 2017 - added double plungers to front legs / shared parts with Naza build YOU NEED TO BE A MEMBER AND LOGGED IN TO SEE THIS SECTION
#Clone 5 rar download#
PLEASE NOTE - THE STL FILES ARE IN THE DOWNLOAD SECTION.
0 kommentar(er)
